ROUND / SCRAP BARRE MT 07 2014-2018

This round / scrapp bar has been designed to be installed without the need to drill into the frame or the fairings of the motorcycle. It is therefore only mounted by screwing onto the plate support and passing through the gills under the saddle.
The plate holder can be reinstalled

The shape of the round / scrapp bar follows those of the shell for optimal discretion and good protection of the rear shell.
 

This set comes with the necessary screws for assembly. (re-use of some original motorcycle screws).





WARNING !



If your vehicle is already fitted with non-original adaptable parts (exhaust, wheel hugger, etc.), there may be interference with the equipment offered. If in doubt, do not hesitate to ask us, modifications are possible. This material

was not designed for use on the open road.

Although very effective, this equipment does not guarantee that your vehicle will not be damaged during your falls.

The photos presented are not contractual.